
Electronics Rigging
Marine electronics installed cleanly and built to last on salt water

Marine Electronics We Rig
We install and wire the electronics that help you find fish, navigate, and stay in touch on the water, and we route everything so it is easy to service later.
Common problems we fix along the way include screens that flicker or reset, sonar that loses bottom at speed, radios with weak range, and loose wiring behind the console. Most trace back to power, grounding, or transducer placement, and we sort those out as part of the job.
- Chartplotters and GPS units
- Fish finders and transducers
- VHF radios and antennas
- Trolling motor wiring
- Battery and charging systems
- LED and navigation lighting
Request An Electronics Install
Tell us about your boat and the electronics you want installed or upgraded, and include photos of your helm if you can. Our service team will follow up with a plan and a quote.
What A Clean Install Looks Like
Electronics only work as well as the rigging behind them. These are the standards we hold every install to.
- Planned Helm LayoutScreens and controls placed where you can see and reach them from the wheel.
- Clean Cable RoutingCables run through proper chases and clamps instead of hanging loose under the console.
- Correct Wire And FusingWire sized for the load and every circuit protected with its own fuse or breaker.
- Sealed Marine ConnectionsHeat shrink and sealed connectors that hold up to salt air and spray.
- Solid Transducer MountingTransducers placed and sealed for a clean sonar picture and no leaks.
- Labeled And DocumentedCircuits labeled at the panel so future work goes faster.
Our Rigging Process
Every electronics job follows the same four steps, from planning the layout to testing on the water.
Plan The Layout
We look at your helm, console space, and power system and agree on where each unit and cable will go.
Mount And Route
Units, transducers, and antennas are mounted solidly and cables are routed out of the way and secured.
Wire And Protect
Every circuit gets the right wire size, its own fuse or breaker, and sealed marine connections.
Test And Hand Off
We power up and test each unit, confirm readings, and show you how everything works.
Why Boaters Trust Our Rigging
Electronics work done carefully the first time.
Built For Salt Water
Marine connectors and sealed wiring that hold up on Galveston Bay.
Experienced Team
More than 120 years of combined marine experience on our team.
Local And Easy To Reach
Find us at 902 FM 518-W in Kemah.
We Know Boats
We sell, service, and rig boats, so we plan each install around how the boat is used.
Electronics Rigging Questions
Yes. Include the make and model of your units on the request and we will plan the install around them.
This is usually transducer placement or mounting angle. Turbulent water behind hull strakes or fittings can blind the sonar, and moving or adjusting the transducer often fixes it.
Yes. We wire trolling motors and add or update batteries and charging systems sized for the load.
It depends on the size of the job. Simple installs can be quick, while a full helm upgrade takes longer, and we give you a time estimate with your quote.
Upgrade Your Helm
Send an electronics request and our team will follow up with a plan for your boat.
